31
Fault
Probable cause
Methods of elimination
The machine is not
draining water.
The drain hose is obstructed or
bent.
Check the drain hose.
The pump filter is obstructed.
Clean the pump filter.
The machine is
vibrating.
Not all transit bolts have been
removed.
Remove all the transit bolts.
The machine is located on an
uneven surface or is not levelled.
Ensure the machine is located on an even
surface and is correctly levelled.
There is only a small load in the
machine.
This is not indicative of a fault.
The washer dryer is overloaded,
or badly loaded.
Do not exceed the load capacity, and
ensure the clothes are loaded evenly.
The washer dryer is leaning on a
solid object.
Ensure the machine is installed away from
other objects.
No water appears
in the drum during
washing.
Not a fault.
Water should remain below the
level of the door/window.
N/A.
The machine stops
before completing its
wash cycle.
Water or electricity failure.
Check the power and water supplies.
Operation stops for a
period of time.
Washer dryer gives an error
message.
Check display codes.
Excessive foam in
the drum.
The detergent is not a low
foaming type.
Check if the detergent is suitable.
Excessive amount of detergent
used.
Reduce amount of detergent used.
The machine fails to
spin.
Unbalanced load.
Add more clothes or try running the spin
cycle again.
Laundry has deter-
gent residues on it.
Non-disolving particles of some
detergents may adhere to your
washing.
Perform an extra rinsing operation using
the “Rinse” programme.
Alternatively, brush the particles off the
washing after it is dry.
Summary of Contents for ci860
Page 38: ...38 NOTES ...
Page 39: ...39 NOTES ...
