CCTV Imports H1169, Installation And User Manual

Page: 38 / 74

38
H1169 installation and user manual
5. Event
This menu is used to inform the user as to an event occurring, this can be by the sounding of
a buzzer or by sending an E-mail to a predefined address.
5-1. Beeper/E-mail Setup
Beep Out
The buzzer can be set to sound on the following occurrences: Video Loss, Alarm input,
Motion detection, Power Loss.
The duration of the beep can be set (1~999 seconds or continuous).
E-mail Out
As well as e-mail on event activations the DVR can be set to send a report on the following
occurrences: Video Loss, Alarm, Motion, Power Loss.
5-2. E-Mail Registration
Within this section up to 3 users can be set-up to receive an email on the occurrence of an
event such as Video Loss / Alarm / Motion or Power Loss. An E-mail will only be sent if the
DVR is sitting on a network with access to the Internet, e.g. through a router.
The user name & e-mail address are set from the on screen keyboard via the mouse.
The Sender Address is the address that will appear on the E-mail received by the user, this
should be set logically to identify the specific DVR.
The report period is used to set how often e-mails are sent: Immediately, Daily or Weekly.
“
Send Test Mail
” sends a test E-mail to the addresses so allowing the installer to verify if
the setup is correct
.
5-3. SMTP Mode
The SMTP(Simple Mail Transfer Protocol) function allows e-mails to be sent over a LAN.
The default is SMTP Mode
“OFF”.
In order to activate SMTP Mode, choose SMTP Mode either IP or Domain first.
Then, put ID, Password, Domain/IP, and port.
Finally press
“SMTP Status Check” to test.
①
②
③