SENSOR PLACEMENT
Select the suitable installation site that insert the sensor probes into the soil around
100mm (4 inch) and sensor should place within 30 meters of the display console to get
the best transmission performance.
Display
console
Soil sensor
placement
100mm
(4 inch)
30m
(100 feet)
Soil
Note:
Signal transmission range of the sensor will be gradually reduced as sensor is inserted
deeper into the soil. To achieve best transmission range, install the sensor on the same
plain of view as the display console.
REFRESH THE READING ON DISPLAY CONSOLE
The sensor transmits once every 5 minutes automatically to the display console. User
may also press the
[ REFRESH ]
key on the sensor to manually refresh the readings if
necessary - please note the refresh may take a few seconds up to a minute.
Note:
Some battery operated display consoles may not support this function, please check
your retailer to get more information.
LOW BATTERY ICON
If the sensor is low in battery, the low battery icon “ ” will display on the LCD of the
display console.
Note:
On the display console, the low battery icon will only appear when the corresponding
channel is displaying.
IMPORTANT NOTE
- Read and keep these instructions.
- Do not subject the unit to excessive force, shock, dust, temperature or humidity.
- Do not cover the ventilation holes with any items such as newspapers, curtains etc.
- Do not clean the unit with abrasive or corrosive materials.
- Do not tamper with the unit’s internal components. This invalidates the warranty.
- Only use fresh batteries. Do not mix new and old batteries.
- Do not dispose old batteries as unsorted municipal waste. Collection of such waste
separately for special treatment is necessary.
- Attention! Please dispose of used unit or batteries in an ecologically safe manner.
-
Technical specifications and user manual contents for this product are subject to
change without notice.
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Warning:
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a n a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
SPECIFICATIONS
Dimensions (W x H x D)
65 x 257.5 x 23.5 mm
Main power
2 x CR2032 button cell
Operating temperature range
-40°C ~ 60°C ( -40°F ~ 140°F ) do not recommend
under freeze condition
RF frequency
915 MHz for US version,
868 MHz for EU or UK version,
917 MHz for AU version
RF Transmission interval
5 minute
RF transmission range
(Place on soil ground)
Up to 30m (100 feet) line of sight
