CCH® Elite Operation and Installation Manual (Model CCH1-HCE) Rev 1.0 3/2020
14
6.1.2
Control Box Preparation
Danger:
Ensure the control box is not plugged into power prior to removing the top cover,
adjusting DIP switches, and wiring in the booster pump. Failure to do so may result in
death or serious injury from electrical shock.
1.
Prior to powering up the control box, verify the output setting and economy mode by removing the top cover and identifying the DIP
switch settings in accordance with the Feed Cycle Settings table in step 4, below.
2.
The DIP switches are located near the top left of the controller and the feed cycle settings are on the top right. See Figure 6, below.
3.
There are 4 DIP switches. Switches 1, 2, 3 control the feed solenoid On/Off time and switch 4 turns the economy mode On/Off.
Figure 6.
DIP Switch Location and Feed Cycle Settings
4. The below Feed Cycle Settings table shows On/Off feed times in seconds based on the combination of DIP switch settings. The higher on
times yield higher chlorine output.
ON/OFF
FEED CYCLES
DIP SWITCH 6/54
11/49 16/44 22/38 27/33 32/28 38/22 44/16
SW1
OFF
ON
OFF
ON
OFF
ON
OFF
ON
SW2
OFF
OFF
ON
ON
OFF
OFF
ON
ON
SW3
OFF
OFF
OFF
OFF
ON
ON
ON
ON
5. Set your desired output and economy mode setting in accordance with the above Feed Cycle Settings table.
a.
For example, SW1 on, SW2 off, SW3 on yields 32 sec On and 28 sec Off for the feed solenoid – Approximately 75% chlorine output of
the feeder.
b. If SW4 is off, the booster pump will be always on. If SW4 is on, the booster pump will run in economy mode and stop 20 sec after the
last feed or wash cycle (or 5 min if the pump just started up).
c. The DIP switches can be toggled at any time with the controller powered off.
6.
Close the top cover of the controller to resume start up.
DIP Switch
Feed Cycle
Settings
