CCE HPS-2185FS, Service Manual

Page: 13 / 49

HPS-2185FS
Condition Minimum Nominal Maximum Unit
0mA 28,41 kV
1mA 26,50 kV
3.2.6 Dielectric Rigid
Adjust the HI_POT equipment to 1500 Vac voltage, and the desired test current, in
accordance with the below specification table. When the TV set has a power
switch, make sure that this switch stay in the ON mode. Connect the ground
terminal of the test equipment in both pins of the line cord TV, and apply the HI-
POT terminal (1.5KV) in every extern metal parts of the TV under test for one
minute. In this condition the electric current must be equal or inferior that shown in
the below specific table
Condition Minimum Nominal Maximum Unit
1500VAC - - 2,00 mA
AC
3.3 Frame geometric
3.3.1 Wide and height of the frame
Preparation:
a) Connect the receiver under test to a 117 Vac line.
Turn ON the TV and adjust the bright and contrast controls to maximum,
and the saturation and volume controls to minimum. Wait the pre hitting
time (see model specification).
b) Apply to the antenna input a 60 dB
µ
V signal – 88% modulated with a
“PHILIPS” pattern ( the preferred channel will be defined by the fabric unit ).
c) Adjust the contrast control to maximum and reduce the bright control until
the black level of the image to turn “black”.
d) Observe the pattern image and make a block count in the horizontal and
vertical direction (see model specification).