CC-ISOBUS CCI 50, Operating Instructions Manual

Page: 248 / 359

CCI.Command
– Introduction
5
1.3 About CCI.Command
CCI.Command comprises 3 modules:
CCI.Command/Parallel Tracking
CCI.Command/Section Control
CCI.Command/Headland Mode
CCI.Command / Parallel Tracking and CCI.Command / Section Control can be
procured and used separately from each other.
CCI.Command /Headland Mode is automatically available if CCI.Command / Section
Control is enabled.
1.3.1 CCI.Command/Parallel Tracking
This module improves, for example, orientation during pesticide and fertilizer
application on fields without any tramlines. More accurate linking driving helps to
avoid
overlaps and missed areas .
The module relates to a parallel guidance aid, which under consideration of the
actual working width indicates the position of parallel tracks and using a lightbar
suggests the necessary steering corrections. The tracks can be recorded as
straight A-B lines or as curves.
1.3.2 CCI.Command/Section Control
Using GPS, the module automatically switches off the sections of a pesticide
sprayer / a fertilizer upon passing over field boundaries and already treated areas
and switches them back on upon leaving them. Possible
overlaps (double
treatments) are thus reduced to a minimum and the driver's work load reduced.
From version 2.0 the module also automatically switches the sections of seed
drills, single grain and potato planters, as well as mowers provided the implement
fulfils the requirements for
ISOBUS section switching. Additionally it is possible to
plot obstacles. Before an obstacle is reached, a warning message is displayed.
The safe operation of the automatic Section Control is only possible using a
Section Control -enabled ISOBUS implement.
The operating mode Section Control is only available in map view once all
implement data has been transferred.