3. Aligning/realigning the vane carriers:
Before installing the vanes into the carriers, it is important to make sure the carriers are
properly aligned as shown in the figure below. Follow these steps to align the carriers,
a) Pull the chain until the carriers stop rotating. The carriers should turn together and face the same direction.
b) If some carriers seem to be misaligned, continue pulling the chain until you hear the cranking sound of the clutch operating.
Keep pulling or turning until the misaligned carriers are automatically adjusted.
4. Installing the vanes:
Before installing the vanes, please make sure that the carriers are positioned correctly. Then insert the
vanes into the carriers. Make sure all the vanes are facing the same direction (figure 4.1).
To remove the vanes:
First remove the
carriers to the open position as illustrated in figure 4.2, then slide a card between the vane and carrier clip to open the carrier
sufficiently and remove the vane.
5. Installing the tension device (recommended):
Unwrap the tension device and remove the adhesive tape. Remove the front
cover (5.1). Fasten two screws to the frame or to the wall to anchor the tension device (5.2). Place the front cover on the installed
tension device and press it until it locks (5.3).
5. Cleaning:
Dust the blinds using a feather duster or a moist cloth. Using a mild and diluted detergent is also okay. DO NOT use
any chemicals or degreasers to clean the surface of the vanes, as they may cause fading or discolouration.
WARNING/MISE EN GARDE
Young children can STRANGLE in cord and bead chain loops. They can also wrap cords around their necks and STRANGLE.
- Always keep cords and bead chains out of children’s reach.
- Move cribs, play pens, and other furniture away from cords and bead chains. Children can climb furniture to get to cords.
- Do not tie cords together. Make sure cords do not twist together and creat a loop.
For more safety information: 1-866-662-0666.
long arm
short arm
Card
Vane
4.1 Installing the vanes
4.2 Removing the vanes
Canadian Blind Manufacturing Inc. 110-5900 No. 6 Road, Richmond BC, V6V 1Z1 T: 604-821-1188 F: 604-821-1199 E: [email protected] www.cdnblind.com
Page 2 of 2
5.1 Removing the front cover
5.2 Securing the tension device
5.3 Locking the front cover
