hyde
SQUARE WALL CABINET
VERTICAL DOOR
ORIENTATION
HORIZONTAL DOOR
ORIENTATION
The wall mounting hardware included with this wall console is intended for
drywall
installation only
. Be sure to use hardware appropriate for your wall type. Whenever
possible, fasten screws directly into a wall stud. If you are unsure about your wall type or
what mounting method you should use, consult a qualified professional or your local
hardware store.
1.
Determine the wall console orientation (vertical or horizontal door) and wall
location.
Using a level for the provided
wall
template, level and mark hole positions for
wall bracket as shown.
Discard wall template.
2. If attaching directly into wall studs, skip to Step 4.
3. For drywall installation, drill a hole slightly smaller in diameter than the anchor. Insert 1
plastic anchor
at each marked hole location and gently tap with a
hammer
until the head
of each anchor is flush to the wall surface.
4. Insert 1
large screw
through each hole in the
wall bracket
and into the corresponding
anchors or studs in the wall. Fully tighten each screw with a
phillips head screwdriver
but do not over tighten.
5. With the assistance of another adult, fit the bracket on the back of the unit onto the wall
bracket. Make sure the unit is firmly seated in the wall bracket.
Wall attachment is now complete.
wall attachment
bracket pre-installed
on wall console
wall attachment
bracket pre-installed
on wall console
wall attachment
bracket
wall attachment
bracket
wall template
wall template
NOTE: Make sure arm hinge is orientated on
top and door opens to the left during wall
attachment assembly
NOTE: Make sure arm hinge is
orientated on the right and door
opens upward during wall
attachment assembly
WALL
WALL
BACK OF
ASSEMBLY
BACK OF
ASSEMBLY
wall bracket
Made in Vietnam - r04
Page 5 of 5
Customer Service
800.606.6252
| Latest instructions available on
www.cb2.com
wall attachment assembly
