use it.
(12) When using the vacuum, start from the lowest level; otherwise, strong suction
may trigger discomfort.
(13) When operating the equipment, start from the lowest energy level and gradually
increase it after the client gets used to it.
(14) You must keep the treated parts moist and avoid operation in dry skin conditions
when operating the instrument. (You should operate the laser pads under dry skin
conditions; otherwise, they may get damaged due to dampness.)
(15) When using the laser pads, their whole surface should contact the skin
thoroughly; they can not only touch a small area.
(16) A better effect can be achieved with the combined use of laser pads with
massage and other equipment.
(17) Laser pads can also be used separately. Just fasten it onto the fatty part for about
30 minutes. A better effect can be achieved with the combined use of hand
technique.
(18) After the operation, clean the equipment with normal saline to ensure its
cleanliness and hygiene so that its service life can be extended.
4. Troubleshooting
(1) I can't start the equipment, and the indicator lamp doesn't light up.
A. Make sure you plug the power cord into a good power socket.
B. Check whether the fuse tube in the back is loose or burnt out.
(2) The equipment doesn't have radiofrequency output, or the output is weakened.
A. Please check whether the handpiece and the plug connecting to the equipment
body are closely linked.
B. The wire inside the handpiece is loose or burnt out.
(3) I can start the equipment, but the laser pads don't have energy output.
A. Please check whether the connecting wire for laser pads is correctly connected to
the main machine.
B. If the solutions mentioned above are not working, please contact the equipment
dealer for assistance.
(4) The vacuum RF doesn't have suction, or the suction is weakened.
A. Check whether the filter is installed correctly.
B. Check whether the handpiece's connecting wire is installed correctly.
C. Check whether the handpiece's connecting wire is damaged.
D. The main machine's suction hole has foreign matter or oil dirt inside. Please check
and clean it.
E. Please check whether the rotating knob for the suction setting is set to zero.
Summary of Contents for MS-23T4SB
Page 1: ...User Manual MS 23T4SB...