Cavium FastLinQ 45000 Series, User Manual

Page: 98 / 342

6–Boot from SAN Configuration
iSCSI Boot from SAN
71 BC0154501-00 P
6. On the iSCSI Initiator Configuration page ( Figure 6-13 ), select the following
parameters, and then type a value for each:
 IPv4* Address
 IPv4* Subnet Mask
 IPv4* Default Gateway
 IPv4* Primary DNS
 IPv4* Secondary DNS
 VLAN ID (Optional). iSCSI traffic on the network may be isolated in a
Layer 2 VLAN to segregate it from general traffic. If this is the case,
make the iS2CSI interface on the adapter a member of that VLAN by
setting this value.
 iSCSI Name . Corresponds to the iSCSI initiator name to be used by
the client system.
 CHAP ID
 CHAP Secret
NOTE
For the preceding items with asterisks (*), note the following:
 The label will change to IPv6 or IPv4 (default) based on the IP
version set on the iSCSI General Configuration page ( Figure 6-11
on page 69 ).
 Carefully enter the IP address. There is no error-checking
performed against the IP address to check for duplicates, incorrect
segment, or network assignment.