Cavium FastLinQ 45000 Series, User Manual

Page: 100 / 342

6–Boot from SAN Configuration
iSCSI Boot from SAN
73 BC0154501-00 P
Figure 6-15. iSCSI First Target Configuration
11. Return to the iSCSI Boot Configuration page, and then press ESC.
12. If you want to configure a second iSCSI target device, select iSCSI Second
Target Parameters ( Figure 6-16 ), and enter the parameter values as you
did in Step 10 . This second target is used if the first target cannot be
connected to.Otherwise, proceed to Step 13 .
Figure 6-16. iSCSI Second Target Configuration
13. Press ESC once, and a second time to exit.
14. Press the Y key to save changes, or follow the OEM guidelines to save the
device-level configuration. For example, in an HPE Gen 9 system, press Y
to confirm the setting change (
Figure 6-17 ).
NOTE
For the preceding parameters with an asterisk (*), the label will change
to
IPv6 or IPv4 (default) based on IP version set on the iSCSI General
Configuration page, as shown in Figure 6-15 .