Cattron DYNAGEN TOUGH Series TE410, User Manual

Page: 47 / 114

DynaGen
TM
TOUGH Series
TM
TE410 - EN
User Manual
47
9M02-9249-A001-EN
Revision A
Name Range Default Setting Description
Display > Display
Page 2
Parameters >
Display for Line 1
Display for Line 2
Display for Line 3
Display for Line 4
•
Engine Hours
•
Oil Pressure
•
Fuel Level
•
Engine Coolant
Temperature
•
Ambient
Temperature
•
Transducer
Start/Stop
Temperature
Page 2
Engine Hours
Oil Pressure
Fuel Level
Engine Coolant
Temperature
page is desired, then set all lines to
“Blank
Line
” and that page will not be shown.
Current Run Time is the amount of time the
engine has been running since the last start
condition.
The following two options are meant to be
displayed if the
“Default Application Menu” is
set to
“Wind Machine Application”:
Ambient Temperature is the value of the
Aux 5 transducer which is expected to be set
to temperature.
Transducer Start/Stop Temperature is the
“Start” and “Stop” setting in the Sensors >
Auxiliary Sensor 5 menu.
Date / Time > Date
Change 1 ~ 31 days
1 ~ 12 months
2000 ~ 2099 yr
----- Sets the date.
Date / Time > Time
Change 0 ~ 23 hr
0 ~ 59 min
0 ~ 59 s
----- Sets the time.
Date / Time >
Daylight Saving Enable
Disable
Enable Turns Daylight Saving Time on or off. This
applies to North America only. Disable for
other locations.
Units > Temperature
Unit Fahrenheit or
Celsius Fahrenheit Selects the temperature display format.
Units > Pressure
Unit PSI or kPa PSI Selects the oil pressure display format.
Run from OFF >
RUN from OFF Enable
Disable
Enable When enabled, allows a user to start the
engine using the RUN button while in the Off
Mode. When disabled, the controller must be
placed in Auto Mode before the RUN button
can start the engine.
5.2 Application Menu
The application menu allows end users to easily adjust parameters related to their specific application. It is not
password protected.
The application menu contents will depend on the Operator Setup > Display > Default Application Menu setting.
One of two menus can be programmed:
•
Tank Level / Float Application Menu
•
Wind Machine Application Menu