CommandPro
®
23 Series
User Manual
20
9M02-9028-A011-EN
Rev 4
Figure 6: Antenna Clearance (Example)
8.2
Receiver Mounting
To ensure safe and reliable system operation, the following items must be considered when selecting a location
for mounting the receiver:
•
Install the receiver in an environment where the ambient temperature during operation does not drop
below -20º F (-7º C) or rise above +160º F (+70º C).
•
Mount the receiver cabinet securely using appropriate locking-type hardware.
8.3
Receiver Wiring
The 23R08A, 23R14A and 23R22 receivers can be prewired with a wiring harness that is permanently attached to
the receiver. The 23RCAN is provided with interface connectors on the receiver. Information on the connection of
the wires is contained inside the cabinet door or on the face of the receiver.
WARNING
Before starting this installation, ensure that the power has been disconnected and that all
applicable safety precautions are followed.
8.4
Power/Control Wiring
The relay circuits are designed to operate at 8 A continuous over all environmental conditions, and they will
withstand momentary surges greater than 8 A. If the combined current in any relay bank exceeds 8 A continuous
or 15 A surge, contact Cattron at
www.cattron.com/contact
regarding proper installation to ensure reliable
operation.
Use the following steps to install the wiring to the receiver:
Connect the positive power wire (+12 VDC or +24 VDC) to a power source on the vehicle. The power
source must be capable of supplying the necessary current for the intended loads. It is recommended that
a separate switch be installed to control power to the receiver.
Connect the ground wire to the chassis. Make sure this is a reliable connection. Use of a star ground lug
is recommended.
Connect the remainder of the wires to the control relays as required.
!
