background image

RECHARGEABLE HEADLIGHT 

HL-EL1025RC

Before using the light, read this 

manual thoroughly and keep it for 

future reference.

Manual

 WARNING!!!

• This light emits an extremely powerful beam equiva-

lent to automobile headlight so it may cause a hazard-
ous situation depending on the beam angle used. 
Be sure to direct the light beam downward so the 
driver approaching does not get dazzled.

• Before your trip, please make sure the light is fi rmly 

mounted to the bracket and it lights up.

• Always attention to the remaining battery power by 

checking the indicator periodically while using.

 CAUTION!

• Do not stare at the light when it is illuminating.

Otherwise it may damage your eyesight.

• Do not place it within children’s reach.
• In preparation for unexpected battery shutoff, we rec-

ommend you carry a spare cartridge battery and light.

• Mounting the light unit too close to a wireless comput-

er may adversely affect the reading of the computer.

• This product is water-resistant under normal daily use 

and can be used in the rain. However, do not inten-
tionally submerge it in water.

• If the light unit or parts become dirty with mud, etc., 

clean with a soft cloth which is moistened with mild 
soap. Never apply paint thinner, benzine or alcohol; 
damage will result.

 LITHIUM-ION BATTERIES

Cautions on recharging

• Avoid charging in direct sunlight or in a vehicle 

parked under direct sunlight, and make sure to 
charge only when the ambient temperature is 
between 41°F and 104 °F (5 and 40°C).

• Before charging, be sure that no dust or other 

foreign objects attach to the USB plug.

• Do not subject the light to vibrations while charging.
• Once charging is complete, be sure to disconnect 

the USB plug.

Cautions in use

• Charging, discharging, and storing in high tem-

peratures will cause the rechargeable battery to 
deteriorate faster. Do not place the light inside a 
vehicle or near a heater.

• When the operating time decreases signifi cantly, 

the battery life is close to an end. Replace the 
cartridge battery with a new one.

Cautions on storage

• Cool and dry storage is recommended. For long 

period storage, it is important to charge the battery 
30 minutes every 6 months.

• When you store the cartridge battery alone, be sure 

to install the cap.
Otherwise, damage or a fi re may be caused by 
short circuit.

Cautions for dispose

Dispose of used cartridge batteries appropriately 

according to local regulations.

 Before Initial Use

This unit is shipped with a small 

charge to check the light. 

Be sure to charge it before use, 

according to the instructions 

“HOW TO CHARGE” and 

“Cautions on recharging”.

1. Connect the light unit to your PC or a commercial 

USB battery charger using the USB cable. 
(

1

 – 

2

The switch lights up, and charging starts.

Switch button light State (charging rate)
Illuminated in red

Charging (less than 50%)

Illuminated in orange Charging (more than 50% )
Illuminated in green Charging is completed

* When your PC is in sleep state, the unit cannot 

be charged.

* Use a USB battery charger of 500mAh (USB2.0) 

or more. The cartridge can be fast-charged with 

high capacity USB battery charger.

2. After charging is completed, remove the USB cable, 

and install the charge jack cover.
* The battery charges to about 80% after approxi-

mately 9 hours.

* Charging time is approximate values, and will vary 

depending on the environmental and usage condi-

tions.

Standard charging time

Approx. 

4.5 – 12 h

1. Mount the bracket to the handlebar. (

1

 – 

3

)

2. Insert the light unit into the bracket until it clicks, 

and adjust the beam angle. (

4

)

 Beam angle adjustment

Turn on the light on a smooth road at night, 

and loosen the dial slightly to move the bracket. 

Adjust the beam angle so it does not direct to 

a driver approaching and then tighten the dial 

fi rmly to fi x the bracket.

3. To remove the light unit, pull out it forward while 

pressing down on the release button (

5

).

CAUTION!:

•  Be sure to tighten the dial by hand. When you 

tighten it too hard with a tool, the screw thread 

may be stripped.

•  Check the dial and screw (*1) on the bracket pe-

riodically, and use them without any loosening.

•  Round off the cut edge of the bracket strap to 

prevent injury.

2 HOW TO MOUNT TO A BICYCLE

1 HOW TO CHARGE

OK

NO!

5

4

1

3

2

2

1

Cartridge battery

(BA-5.2TF)

FlexTight™ bracket

(H-34N)

USB cable

(MICRO USB)

Light unit

ENG

USB cable

Charge jack cover

To PC or USB battery 

charger

Dial

Rubber pad

Bracket

Strap

Release button

Screw

*1

Design Pat. Pending

Copyright© 2018 CATEYE Co., Ltd. 

EL1025RC-180514 

Reviews: