5
UK
Telephone Helpline: 0845 146 2887
7.
To turn one zone off, press and hold the
Decrease key. To turn both zones off, just
press the On/Off key.
• To lock/unlock the control panel, press and
hold the lock key.
• This appliance has an overheat protection
function. If the pan becomes too hot the
appliance will switch off, a buzzer will sound
and the display will show “E2”. Should this
happen, allow the appliance to cool before
restarting.
• Fan will continue to run while the glass surface
temperature is over 80°C.
Using the timer
• When in Power or Temperature mode, press
the FUNCTION key again to enter/view the
timer.
• Press the Increase or Decrease key to change
the timer.
Function
Level
Increments
Default
Timer
0 to 180min
5min
0min
• When the set time expires, the appliance will
switch off automatically.
Boost function
• For faster cooking press the boost key. The left
zone will work at 2000W while right zone at
1000W.
• Put your pan on the left zone for fast cooking.
• The Boost mode can only last 10 minutes.
Afterwards, the left zone will work at 1800W
automatically.
Cleaning, Care &
Maintenance
Disconnect from the power
supply and allow the appliance
to cool before cleaning.
• Use warm, soapy water and a damp cloth to
clean the appliance.
• DO NOT use abrasive cleaners or pads.
• Dry thoroughly after cleaning.
• A CATERLITE dealer or qualified technician
should carry out repairs if required.
Troubleshooting
Fault
Probable Cause
Solution
The unit is not working The unit is not switched on
Check the unit is plugged in correctly and
switched on
Plug and lead are damaged Call Caterlite agent or qualified technician
Fuse in the plug has blown
Replace the plug fuse
Power supply
Check power supply
Unsuitable cookware
Replace with suitable cookware
“E0” on Display
Unsuitable cookware / no
cookware
Replace with suitable cookware
“E1” on Display
Appliance has overheated
Check ventilation slots for blockages. Allow to
cool before attempting to use again.
“E2” on Display
Temperature of pan is too
high (Pan is dry or empty)
Remove cookware. Allow to cool before
attempting to use again.
“E3” on Display
Input voltage is too high/
low
Make sure the mains power supply is suitable
for the appliance.
DF824_UK_A5_v1_20180703.indb 5
2018/7/3 16:19
