INSTALLATION INSTRUCTIONS
•
This appliance is designed to be free standing only, and should not be
recessed or built
-
in.
•
Place your unit on a floor that is strong enough to support the unit when
it is fully loaded. To level your unit, adjust the levelling legs at the bot-
tom of the unit.
•
This appliance is NOT designed to be installed inside of a cabinet where
the front is covered by any type of door.
•
Allow 10cm of space between the top, back and sides of the unit, which
allows the proper air circulation to cool the compressor and condenser
•
Locate the unit away from direct sunlight and source of heat (stove,
heater, radiator etc.)
•
Direct sunlight may affect the acrylic coating and heat sources may
increase electrical consumption. Extreme cold ambient temperatures
may also cause the unit not to perform properly.
•
Avoid locating the unit in moist areas.
•
Plug the unit into an exclusive, properly installed
-
grounded wall outlet.
Do not under any circumstances cut or remove the third (ground) prong
from the power cord. Any questions concerning power and/or grounding
should be directed toward a certified electrician or an authorised Avanti
Products service centre.
•
After plugging the appliance into a wall outlet, allow the unit to cool
down for 2
-
3 hours before placing food in the appliance compartment.
4
