537100 G20NE
9
EN
G
LI
S
H
OPERATION AND USE
• The mixing kneader has 3 speeds between 100 and 500 rounds per minute.
• The timer can be set up to 60 minutes.
• Press
ON/OFF
to switch the machine on and off. This function only works if the bowl is properly
attached, the lift is raised and the bowl guard is closed.
• If the bowl is lowered or the protective cover is moved, the device will automatically switch off
(OFF)
via
a microswitch. This microswitch will protect you against injuries.
• During use, you can add ingredients through the pouring spout found on the right side of the bowl’s
protective cap.
• Set the speed using the left rotary control and set it to position 1, 2 or 3. You can set the timer using the
digital control panel. Press the up or down arrows to confirm the desired time. You do not need to press
ON
and/or
OFF
for this.
• You can also adjust the speed and timer during use.
CLEANING AND MAINTENANCE:
Step 1: After usage, the device must first be switched
OFF
, after which you must remove the plug from the
socket. Always do this in the order described to prevent short circuit or other possible dangers.
Step 2: Remove the parts (such as the bowl and mixing tools).
Step 3: Clean the parts and the device with warm water, a wet cloth and a small amount of cleaning-
detergent and then dry it thoroughly. Do not use benzine, thinner, scouring brush or polishing
powder to clean the device.
•
Pay attention!
Do not rinse the device with water (don’t wash it by using the tap).
This could cause damage to the device and could therefore lead to dangerous situations.
• Never clean the device with a stainless steel brush. This causes scratches and damages to the device.
• Use a vacuum cleaner to (gently) remove dirt and debris from the air-ventilation-grille.
• Always store the mixer inside and keep it dry.
• The transmission case and planetary gears are filled with special grease that will last for several years.
Replacement of the grease must always be done by an authorized (certified) service technician.
• Before maintaining the mixer, always make sure you have removed the plug from the socket.
If the mixer does not work or is damaged, check the following:
1. Whether the plug is in the socket;
2. Whether the plug and / or the cord is damaged;
3. Whether the microswitch works.
If it is nr. 2, 3 or if another problem occurs, contact your local dealer or authorized service technician.
According to Waste of Electrical and Electronic Equipment (WEEE) directive, WEEE should be
separately collected and treated. If at any time in future you need to dispose of this product
please do NOT dispose of this product with household waste. Please send this product to WEEE
collecting points where available.
