7
REASSEMBLY FOR SEALS
NOTE: Examine inlet and discharge manifolds, spacers, male and female adapters for grooves, pitting or wear and replace as needed.
NOTE: Examine o-rings, low-pressure seals and v-packings for cuts or wear and replace with a new seal kit as needed.
2.22 With crankcase side of inlet manifold facing upward, install low-pressure seals with coil spring facing down.
2.23 Turn inlet manifold over.
2.24 Install female adapter in each seal
chamber with flat surface facing down.
2.25 Install the pair of v-packings in each seal
chamber with v-shape facing down.
2.26 Install male adapter in each seal
chamber with v-shape facing down.
2.27 Install and lubricate o-rings on both
ends of v-packing spacer.
2.28 Install v-packing spacer in each seal
chamber of discharge manifold.
2.29 Install and lubricate o-rings on both
ends of inlet spacer.
2.30 Install inlet spacer in each seal chamber.
NOTE: The seal kit contains three (3)
plunger retainer o-rings and should
be replaced at this time prior to
re-installing manifolds.
Summary of Contents for 67102
Page 15: ...15 ...
