CASTOR Static Oven, Operating Instructions For Use And Installation

Page: 5 / 22

18 18
GB
ELECTRICAL CONNECTION
The appliances are provided with a three-pole feeding cable and work with alternate cur-
rent and single-phase voltage of 220...240V - 50...60Hz. The grounding conductor of the
cable is marked with the colours yellow/green.
CONNECTION OF THE FEEDING CABLE TO THE MAINS
Connect the feeding cable of the oven to a plug suitable for the load indicated on the
rating plate of the product (fig. 1 and 2). In case of a direct connection to the mains (cable
without plug), it is necessary to insert a suitable omnipolar switch before the appliance,
with minimum opening between contacts of 3 mm (the grounding wire should not be inter-
rupted by the switch).
Before connecting to the mains, make sure that:
• the electrical counter, the safety valve, the feeding line and the socket are adequate to
withstand the maximum load required (see rating plate).
• the supply system is regularly grounded, according to the regulations in force.
• the socket or the omnipolar switch can easily be reached after the installation of the
oven
• after carrying out the connection to the mains, check that the supplying cable does not
come into contact with parts subject to heating.
• never use reductions, shunts, adaptors which can cause overheating or burning
(fig.3).
The manufacturer is not liable for any direct or indirect damage caused by faulty instal-
lation or connection. It is therefore necessary that all installation and connection opera-
tions are carried out by qualified personnel complying with the local and general regu-
lations in force.
INSERTION AND ASSEMBLY
Insert the oven into the opening of the furniture, resting it on the base and pushing it as
far as the ledge of the side stanchions against the shoulder of the piece of furniture. For
the dimensions of the oven see illustration.
•Open the door and fix the oven with four wood screws to be screwed up through
the holes in the side stanchions of the oven (fig. 4)
•The sides and the base surface where the oven is to be installed should be milled
as shown in fig. 5 to allow a safe air intake and a free air circulation around the
oven, thus granting its good operation and avoiding damages to the furniture.
Pay attention to fix the ovens in an absolutely firm way, as above indicated, and
to insulate the electrical elements in order to avoid an eventual contact with
metallic parts.
NOTES FOR THE INSTALLATION
053 ed Statico4/2000 21-11-02 20:29 Pagina 18