CBW560 Series Cable Modem
Wireless Router
User’s Manual
4
2.2 Rear Panel and Hardware Connection
This chapter describes the proper steps for connecting your cable modem.
Please be sure to follow the steps in the sequence outlined below. Failure to
do so could result in improper operation or failure of your cable modem.
Step 1:
Connect a cable by feeding the F-connector on the back of the cable
modem. Ensure the center conductor of the 75 ohm coaxial cable is inserted
directly into the center of the F-connector. Secure the coaxial cable by
carefully threading the outer shell of the coaxial cable connector onto the F-
connector in a clockwise direction until tight. Be careful not to over-tighten the
connector or you may damage either the connector or the cable modem.
Step 2:
Connect the data cable modem to an IEEE 802.3 10BaseT / 802.3u
100Base-TX Network using a RJ-45 male-terminated Ethernet cable or an
USB cable to the PC.
Step3:
Connect the AC Adapter to the cable modem by inserting the barrel-
shaped connector into the mating power connector on the back of the cable
modem. Exercise carefully to ensure the connectors are properly aligned prior
to insertion and ensure the two connectors engage completely. The cable
modem is shipped with an AC adapter. Remember to use only power adapter
that came with the cable modem. Other power adapters might have voltages
that are not correct for your particular cable modem. Using a power adapter
with the wrong voltage can damage the cable modem.
z
This product can be mounted on wall, There are two holes in the lower
case , you can use the screw to mount it.
Step 5
Adjust the Antenna
Step 2
Connecting to a Network Interface Card
Or Connecting to the USB port on your PC
Step 1
Connecting
the Coaxial Cable
Step 4
Connecting to
the AC Adapter
Reset Button