2.1.2
Setting the System using the Keyswitch (if fitted)
Step
Action
Response
Display
a
Verify that all doors, etc. are closed,
and that '
d
' prompt is displayed
'
d
'
b
Insert your key and turn from the 'OFF'
position to the 'FULL' or 'PART' ('B')
on position, as required.
If the keyswitch has been left in an
'ON' position by switching off with the
keypad, switch to 'OFF' first, then
proceed as above.
Acceptance of code will be
confirmed by display showing
a single 'bar' (flashing if PART
set). After a few seconds, a
steady tone will commence.
'
-
'
(flashing if
PART set)
c
Remove your key and leave the
building by the specified route.
To set the system silently (eg at night
if part of the family is asleep): press *
within 2 seconds of completing step b.
Continuous tone sounds.
Tone will be aborted.
'
-
'
(flashing if
PART set)
d
Then proceed as described for using
the keypad.
2.1.3
Setting the system to Part Set 'C'
This facility is available only if programmed by the installing engineer.
Step
Action
Response
Display
a
Press C, followed by #
If no 'C' key, use 9 #
Acceptance of code will be confirmed by
display showing a single 'bar' (flashing if
PART set). After a few seconds, a steady
tone will commence.
'
-
' flashing
b
Leave the area to be
protected by the system
Wait for the tone to silence.
'.'
It is possible to adjust the zones on which Part Set 'C' operates, as described at 6.4
2.2
Omitting Individual Zones
This facility is available only if programmed by the installing engineer.
Whilst the continuous exit tone is sounding, press the number of the zone you wish to
omit, followed by '#' - repeating for additional zones if required (up to 3). The number of
the omitted zone with be displayed, and the last number will remain on the display until
the system sets.
Castle Care-Tech Ltd.
Page 8
Issue 3a