MAMBA X SPECIFICATIONS
Application
Guidelines
• 1:10th scale buggies, stadium trucks, touring cars,
crawlers and short course trucks weighing up to 7lbs.
• 1:8th scale buggies, geared for off-road racing, weighing
up to 9lbs.
Input Voltage
Range
Min: 2S LiPo, Max: 6S LiPo, 25.2V
BEC Specifications Adjustable: 5.5V, 6.0V, 7.5V, or 8.0V (8A Peak), default 5.5V
Waterproof
Yes*
Sensors
Yes, including Smart Sense
™
feature.
Product Use
Statement**
• Applying voltages higher than 25.2V will cause irreparable
damage to your controller.
• Recommended battery capacity for 1:8th and 1:10th scale
vehicles is 5000mAh or larger. We recommend using 30C
continuous discharge or higher LiPo batteries (or high
quality 25C batteries such as Traxxas® Power Cell).
• The Mamba X has 4.0mm bullet connectors directly on the
ESC and the battery input wires are bare. You must add the
connector of choice to the battery leads. We recommend a
high-current connector rated for 70+ amps.
• The Mamba X is not intended for human or animal
propulsion.
RECEIVER CONNECTION
RX Wire
Plug the RX wire into the throttle (#2) channel on your
receiver.
AUX Wire
The AUX wire allows you to adjust a setting “on-the-fly”
using an auxiliary channel on your receiver. The AUX wire
function is disabled by default and is programmable via
Castle Link. Plug this wire into the auxiliary (#3/#4) channel
on your receiver. If you are not utilizing the Aux wire
function you can leave it disconnected from your receiver.
Contact
Castle Creations, Inc.
540 North Rogers Road
Olathe, KS 66062
(913) 390-6939 (ext. #1 Support, #3 Sales)
Product Support: [email protected]
Sales: [email protected]
Website: www.castlecreations.com
TRANSMITTER PROGRAMMING REFERENCE
AUDIBLE ALERT REFERENCE
• •
Start Fail
• –
Low Voltage Cutoff
– •
Over-Current
• • •
Sensors Lost
• • –
Radio Glitch
• – •
Over-Temperature
• – –
Excessive Load
– • •
AUX Wire Radio Glitch
– • –
BEC Over-Temperature
• • • •
Data Log Full Warning
1.Brake/Reverse Type
3. Brake Amount
5. Motor Type
• With Reverse*
• 25%
• Brushless*
• Without Reverse
• 50%*
• Brushed Reversing
• Crawler Reverse
• 75%
• Brushed High Power
•
100%
2.Voltage Cutoff
• Auto-Lipo*
4. Drag Brake
•
None
•
Disabled*
•
10%
•
20%
•
30%
•
Crawler
Full
On
*Default Setting
See Driver’s Ed
Guide, “Transmitter
Programming”.
*Not intended for operation while submerged in liquid. If unit is operated in wet conditions, rinse with fresh
water to remove dirt or corrosives, then fully dry unit.
**Failure to adhere to the Product Use Statement constitutes a violation of the warranty agreement, and will
result in non-warranty service fees to repair or replace damaged products.
