Cassese CS1 CART, User Manual

Page: 10 / 48

Non contractual document - Cassese France
®
- Document non contractuel
JOINING THE FRAME
After selecting and setting the wedge positions (page 4 & 5), check the distance
between the clamp and the moulding (page 6). Load the required type (softwood,
hardwood or MDF) and size of wedges (page 4).
1
st
step : Put the first moulding in front of the back fence 1 and push it so that its
mitre end reaches the other back fence 2 .
2
nd
step : Holding it so, put the second moulding against back fence 2 and slide it
until it reaches the first moulding.
3
rd
step :
Holding the mouldings in place against each other, hold the back fences
1
& 2
with your thumbs. Move the sliding table
E
backwards until the wedge position
stop handle
5
reaches the stapling stop
10
.
4
th
step :
Keeping the mouldings secure, slowly push down the pedal
7
.
When the the magnetic adjustable rod clamp assembly
8
will press down on the
mouldings, speed up the movement so that the wedge is inserted more easily.
5
th
step : If there is a second wedge position (with wedge position stop handle 6 ),
just repeat the same operation by moving forward the mouldings and the sliding
table E until wedge position stop handle 6 reaches the stapling stop 10 and repeat
step 4.
NOTE* : If stapling more than one wedge in any position is desired then repeat 4
th
step .
7
9
6
5
10
2
1
8
3
4
11
7