EN
USE
1. Description of the key
1.1 Key "
": Short press to set the temperature / long press to switch the machine on and off.
1.2" " Button: For temperature setting / long press / switch
2. Operating Instructions
2.1 Power on/off (if the next key is an effective key, the buzzer will emit a short tone to remind the key).
2.1.1 When the system is powered on, press the external power switch to the "I" position to turn on the
system; the controller operates according to the state saved at the last power failure. If it was in the off
state before the power failure, it is in the off state after the power failure. If it was working before the
power failure, it is working after the power failure.
2.1.2 In the off state, press the "
" for 3 seconds, then start the machine; in the same working state, press
and hold "
" for 3 seconds, and the system will shut down. The power on/off status is saved in memory
without battery.
2.1.3 Press the external power switch to the "o" position and turn off the three-way display panel.
2.2 Temperature setting
2.2.1 When the device is powered on, press the "key" once " Where "
"to enter the temperature setting
state, the temperature setting value flashes, press the key again" " Where "
", the temperature setting
value increases or decreases by 1, long press the " " Where "
", and enter the key acceleration state
one second later, and the setting value will increase or decrease by 1 every 0.3 seconds. The setting
value will be increased or decrease by 1 every 0, 3 seconds.
2.2.2 Temperature setting range 30°C - 70°C, Factory default 60°C STEP=1°C .
2.2.3 In the temperature setting state, if no key is pressed for more than 5 seconds, the temperature setting
state will exit and return to the normal display.
The set value will be saved.
2.3 Celsius/Fahrenheit switching operation
2.3.1 When the machine is started normally and it is in Celsius mode, press the " " for a long time, and the
beeper will emit a long sound after 3 seconds, and the monitor will indicate " F " And vice versa.
2.3.2 Celsius/Fahrenheit display status will be saved.
Error code :
Code
Description
EL
Temperature sensor open circuit or lower temperature
EH
Temperature sensor short-circuited or overheated
REMARK
The appliance is equipped with a safety system in case of overheating. In the event of tripping, unplug the
appliance and allow it to cool. If this protection system activates regularly, it is essential to contact your
retailer.
After automatic shutdown, the device can only be put into operation by pressing the Reset button on the back
of the device. To do this, wait for the temperature to drop, press the Reset button.
WARNING
Never place dishes directly on the shelves.
When the cup warmer is on, some parts of the appliance become hot.
To avoid any risk of burns, do not touch hot surfaces with bare hands, wear protective gloves.
