6
TILE Installation
The TILE is designed to be mounted in place of a standard 2 ft x 2 ft ceiling tile.
Installation is only to be performed by a qualified electrician. A power switch turns
the unit ON and OFF.
1. Remove the ceiling tile where the TILE unit will be placed.
Be mindful not to place by a return duct.
2. Place TILE unit into the open ceiling square.
3. Hardwire TILE unit into an available power source. This is to be performed by a
licensed professional.
Service and Maintenance
Service should only be performed by a qualified technician. Make sure the power
switch is turned OFF and the unit is unplugged prior to handling.
It is recommended maintenance to vacuum off the vent openings and clean the
under side of the unit if any dust build-up has accumulated.
A face mask should be worn to prevent inhalation of any particles released into the
air during the process. Eye protection may be necessary when cleaning the unit
from below while it is mounted in the ceiling.
1. Open the front door of the TILE unit.
2. Remove the Bracket Assembly by
unscrewing the top thumb screw.
3. Remove the 2 additional screws
from the Bracket Assembly.
4. Remove the Cell Assembly from the packaging box.
