Disposal of the Old Device
caso Pro Chef 1800
26
7 Troubleshooting
This chapter provides you with important notices with regard to
operating the device. Observe the following notices to avoid
dangers and damages:
7.1 Safety notices
Attention
►
Only qualified electricians, who have been trained by the
manufacturer, may carry out any repairs on electrical equipment.
►
Improperly performed repairs can cause considerable dangers
for the user and damages to the device.
7.2 Fault indications
In the event of a fault, an error code will appear in the
display; it describes the cause of the fault.
Error Code
Cause
Solution
E01
Supply
voltage too
low
Ensure that the supply
voltage matches the voltage
shown on the type plate of
the device.
E02
Supply
voltage too
high
Ensure that the supply
voltage matches the voltage
shown on the type plate of
the device.
E03
Possible
short circuit
Please send the device to
customer service.
E05
Temperature
sensor
defective
Please send the device to
customer service.
E06
Overheat
protection
(in power
mode)
Remove the cookware and
allow the device to cool
down. Then turn the device
off and on again.
