9
Take any packaging materials that are no longer
required to “Green Dot” recycling collection
points for disposal.
Please note
► If possible, keep the original packaging for the device for the duration of the guarantee
period of the device, in order that the device can be re-packaged properly in the event of a
guarantee claim.
3.4.1 Setup location requirements:
In order to ensure the safe and trouble-free operation of the device, the setup location must
fulfil the following prerequisites:
Place the device on a firm, flat, level and heat-resistant surface with sufficient load-
bearing capacity for the device and its contents.
Dot not place the device on a metal surface.
Choose the setup location in such a way that children cannot reach any hot surfaces on
the device.
The device is not intended to be installed in a wall or a built-in cupboard.
Do not set up the device in a hot, wet or extremely damp environment or near flammable
material.
Do not place the device near a gas or electric cooker or an oven.
The device requires an adequate flow of air in order to operate correctly. Place the device
with the backside against a wall (with
4” distance). Keep 8” free space at the other sides
of the device.
Do not cover up any openings on the device and do not block these off.
The electrical socket must be easily accessible so that the power lead can be
disconnected easily, in the case of an emergency.
The device and power cord should not come in contact with hot surfaces. The device
could be damaged.
The installation and assembly of this device in non-stationary setup locations must be
carried out by specialist companies / electricians, provided they guarantee the
prerequisites for the safe use of this device.
3.5 Electrical connection
In order to ensure the safe and trouble-free operation of the device, the following instructions
must be observed for the electrical connection:
Before connecting the device, compare the connection data (voltage and frequency) on
the rating plate with those of your electrical network. This data must agree in order that no
damages occur in the device. If in doubt, ask your qualified electrician.
The electrical outlet must be protected by a 16A safety cut-out switch, separately from
other electricity consumers.
