CASO DESIGN HW 660, Original Operating Manual

Page: 35 / 117

35
14.1.3 Set the water hardness
Press and hold Clean-button
, the display shows „001“ or „002“ as Volume. „001“
stands for soft water. This means that „Descale“ will light up in the display after 60 litres of
water were dispensed. „002“ stands for hard water. This means that “Descale” will light up in
the display after 25 litres of water were dispensed. With the Volume-button you can
change between „001“ and „002“ confirm with
Start/Stop.
14.2 Use
1. Fill the watertank with water, you can remove it to do this.
2. Place your cup on the removable drip tray, make sure it aligns with the spout.
3. First press Lock-button about 3-5 seconds for unlocking the device,.
4. Press Temp-button to choose your desired temperature and press Volume-
button to set the water volume.
5. Press Start/Stop-button to start the device. The desired water volume will flow out from
water spout. Press Start/Stop-button again, to stop the device. The device will stop
working at once.
6. Alternatively: Press and hold Baby-button for dispensing of water with 40°C for
preparation of baby food. Water with 40°C will be dispensed as long as button is pressed.
Please note
► Do not fill milk into the device.
Warning
►
Avoid the risk of burns: Please check the temperature of the food before you give it
to your baby. This can easily be done on the back of your hand.
7.
If you want to dispense water again, repeat the steps above.
Please note
► If only a small amount of water is dispensed, then the desired temperature may differ.
Preheat the vessel.
► If device was not used for longer time there could be scale deposits despite water filter. In
this case let 100 ml with 100 °C run through the device.