EN-21
Adjusting the Position, Elevation, and Angle
1.
Turn on the projector.
If the projector is in its initial factory default setup, it will project a blue screen (when there is no
input signal).
Projection of a test pattern is recommended, if possible. For more information, refer to the
projector’s User’s Guide.
Important!
Important!
Important!
Take care to keep your hands away from the area around the projector’s exhaust vents while
the projector is turned on. The locations of exhaust vents depend on the projector model. For
information about your projector operation, refer to its User’s Guide.
2.
To begin adjustment, loosen the four screws shown in the illustration.
Use the included hex wrench to loosen Screw (4).
1. Start adjustment.
(1)
(2)
(3)
(4)
Summary of Contents for YM-81
Page 31: ...MA2001 C...
