Getting Ready
E-10
After you finish configuring the initial settings of the two projectors, perform the procedure below to
configure initial Control Box settings.
To configure initial Control Box settings
1.
Press the remote controller [ALL] key (or [1] key) to turn on Control Box power.
z
This also turns on the two projectors linked to the Control Box.
2.
On the remote controller, press the [MENU] key to display the setup menu.
z
Under initial default settings, menus are displayed in English.
3.
Select “Option Settings” and then “Language”, and then use the [
U
] and [
I
] keys to
select the language you want.
4.
Configure the settings below as required. For details about each setting, refer to the
“YA-S10 User’s Guide”.
z
Option Settings
3
Eco Mode
z
Image Properties
3
Color Mode
z
Option Settings
3
Remote Power Numbers
5.
Next, perform the procedure under “Adjusting the Positions of the Two Projectors”
(page E-11).
Control Box Power On/Off
The Control Box remote controller has five power keys. Four of them are numbered from [1] to [4], and
the fifth one is marked [ALL]. This allows power on/off control of multiple Control Boxes in the same
location.
z
Pressing the [ALL] key turns on all of the Control Boxes.
z
Keys [1] through [4] control the Control Boxes that are assigned the corresponding number with the
“Option Settings
3
Remote Power Numbers” setting.
Configuring Initial Control Box Settings
Perform the operations below using the Control Box remote controller (YT-200). Note that these
operations cannot be performed using the projector remote controller (YT-120).
