37
Operating the Projector
Unless specifically noted otherwise, the operations in this section are performed using the remote
controller. If both the projector and the remote controller have the same key, either one can be used to
perform the corresponding operation.
This section explains how to turn projector power on and off, and provides information about power-
related settings.
For information about the general procedure that is required before turning on the projector, see
“Operation Flow to Projection” (page 20).
To turn on the projector
1.
Connect the provided power cord to the projector’s AC terminal and plug in to a
power outlet.
Wait until the POWER/STANDBY indicator lights red.
2.
Press the [
P
] key to turn on the projector.
This will cause the POWER/STANDBY indicator (green) to flash for a few seconds, and then
stop flashing and remain lit.
The projector will perform an auto input search operation at this time. If it finds an input signal,
it will start projecting its image. For details, see “Using Auto Input Search” (page 39).
Note
For details about what indicators show, see “Normal Operation Indicators” (page 66).
To turn off the projector
1.
Press the [
P
] key.
This will cause the POWER/STANDBY indicator (red) to flash for a few seconds, and then stop
flashing and remain lit.
2.
Unplug the power cord from the power outlet and then disconnect it from the
projector.
Direct Power On
When “On” is selected for the “Option Settings 1
Direct Power On” setting (page 60), the projector
will turn on automatically whenever you plug its power cord into a power outlet. (Initial default setting:
“Off”).
Turning the Projector On or Off
