Casio QW 5513, Operation Manual

Page: 12 / 19

Swapping Your Current
Location Time and Dual Time
Settings
You can swap the time in your current location
with the Dual Time by holding down (B) for
about three seconds.
●
Pressing (B) will cause illumination to turn
on. Keep the button depressed for three
seconds.
30 30
After swapping Before swapping
Dual Time
Dual Time
Current location time
Current location time
Note
●
If you are using the small hour and
minute hands for Dual Time, only the
time in your current location will be
swapped with Dual Time. Dates are
not swapped.
Stopwatch
The stopwatch can measure elapsed time up
to 23 hours, 59 minutes, 59 seconds.
Note
●
If an ongoing elapsed time
measurement operation continues
for 24 hours, the measurement will
stop and the stopwatch will reset to
all zeros automatically.
Getting ready
Perform this procedure in the Stopwatch
Mode.
l
Navigating Between Modes
30
Stopwatch Mode
Measuring
30
24-hour Minutes
Hours
Seconds
1.
Use the operations below to measure
elapsed time.
B
B
B
B
Stop
Resume
Stop
Start
2.
Press (D) to reset the elapsed time to all
zeroes.
3.
Press (A) three times to return to the
Calendar Mode.
Measuring a Split Time
30
24-hour
Minutes
Hours
Seconds
1.
Use the operations below to measure
elapsed time.
●
Each press of (D) causes the elapsed
time up to that point (split time) to be
indicated for 5 seconds.
B
D
B
Stop
Split
Start
2.
Press (D) to reset the elapsed time to all
zeroes.
3.
Press (A) three times to return to the
Calendar Mode.
Note
●
Up to 100 split times can be measure
during a single elapsed time
operation.
Timer
The timer counts down from a start time
specified by you. A beeper sounds when the
end of the countdown is reached.
●
The beeper is muted in the cases described
below.
ー
When battery power is low
Getting ready
Perform this procedure in the Timer Mode.
l
Navigating Between Modes
30
Timer Mode
Setting the Time
1.
Pull out the crown to the first click.
2.
Rotate the crown to change the
countdown start time setting.
●
The countdown start time can be set in
1-minute units up to 24 hours.
30
Crown
Seconds
Minutes Hours
24-hour
3.
Push the crown back in.
Note
●
You can set a countdown start time
of 24 hours by aligning the small 24-
hour hand with 24.
Operation Guide 5513
12