Using the Timer
1.
Enter the Countdown Timer Mode.
l
Navigating Between Modes
Minutes, seconds
2.
Use the operations below to perform a
timer operation.
D
D
D
(Time up)
Resume
Pause
(Countdown starts)
Start
●
A beeper will sound for 10 seconds to
let you know when the end of a
countdown is reached.
●
You can reset a paused countdown to
its start time, by pressing (A).
3.
Press any button to stop the tone.
Alarms and Hourly
Time Signal
The watch will beep when an alarm time is
reached. You can set up to five different
alarms. The hourly time signal causes the
watch to beep every hour on the hour.
●
The alarm sound is muted in the cases
described below.
ー
When battery power is low
ー
When watch is at Level 2 power saving
l
Power Saving Function
Configuring Alarm Settings
1.
Enter the Alarm Mode.
l
Navigating Between Modes
2.
Press (D) to scroll through alarm numbers
([AL1] to [AL5]) until the number of the
alarm you want to configure is displayed.
Alarm time
Alarm number
3.
Hold down (A) for at least two seconds.
Release the button when the hour setting
starts to flash.
Hours
4.
Use (B) and (D) to set the alarm hour.
●
If you are using 12-hour timekeeping,
[PM] indicates p.m.
5.
Press (C).
This causes the minutes digits to flash.
Minutes
6.
Use (B) and (D) to set the alarm minute.
7.
Press (A) to complete the setting
operation.
8.
Hold down (C) for at least four seconds to
return to the Timekeeping Mode.
●
To stop the alarm
To stop the alarm after it starts to sound when
an alarm time is reached, press any button.
Note
●
A beeper will sound for 10 seconds to
let you know when the alarm time is
reached.
Configuring the Hourly Time
Signal Setting
1.
Enter the Alarm Mode.
l
Navigating Between Modes
2.
Press (D) to display the hourly time signal
screen ([SIG]).
3.
Press (A) to toggle the hourly time signal
between enabled (on) and disabled (off).
●
[SIG] (hourly time signal) is shown on
the display while the hourly time signal
is enabled.
4.
Hold down (C) for at least two seconds to
return to the Timekeeping Mode.
Turning Off an Alarm or the
Hourly Time Signal
To stop an alarm or the hourly time signal from
sounding, perform the steps below to turn it
off.
●
To have an alarm or hourly time signal
sound again, turn it back on.
Note
●
Indicators are displayed while any of
the alarms or the hourly time signal is
turned on.
●
The applicable indicators are not
displayed while all of the alarms are
turned off and/or the hourly time signal
is turned off.
Alarm
Hourly time signal
Watch Operation Guide 5550
12