43
2.8.3
Reset and resume control
When a power on factor occurs, resume or reset is used to start the system.
A reset clears program execution status.Therefore, data on the RAM in work is discarded, because
there is a possibility that in the middle of writing a file is corrupt, you need to be careful.Resume,
will return to the program execution state before power OFF.
(1)Resume
If the device has had its power turned off (to suspend) normally, it resumes the next time its power
is turned on.Resume, and continue the process that was running the last of the power supply is
OFF.Program execution memory in RAM, unsaved data in use, and data in data storage memory
and FlashDisk are retained.
(2)Reset
When you press the RESET button, or you can run when you perform a soft reset function.
Running program is discontinued, after shutdown process, and then run the reboot of the OS.Root
disk (¥, ¥ Windows folder, etc.) and registry information, FlashDisk, data on the SD card will be
retained.
[Caution]
(1) If you lock the system during the reset process (when no response time is more than about 10
seconds), it will be forced to reset by skipping the shutdown process.
(2)When not restarting the body even if a RESET button is pressed, please do the following
operation."CLR" while a key and a "0" key are being pushed, a RESET button in the body back
is pressed.
(3)Full reset
This occurs if both Fn and CLR keys are held down at the same time and then the Reset button is
pressed for a period of one second or longer, by default, while the terminal is in operation.
Running program is discontinued, after shutdown process, and then restart the OS.
In this situation, the confirmation message “OK to clear?” is displayed twice. Use the right trigger
key and left trigger key to confirm. If the right trigger key is pressed in response to both times the
confirmation message is displayed, the memory (data storage memory, and OS and program
execution memory) is cleared, and initialization is performed. However, data on FlashDisk is
retained.