Operation Guide IC-01
2
CONFIGURING THE DIGITAL TIME SETTING
1. Press the
SET button
to cycle through the setting screens as shown below.
Year Setting Screen
Month and Day Setting Screen
12-hour/24-hour Setting Screen
Time Setting Screen
Current Time Screen
Day of the week
PM indicator
Current time
(Hour, minutes)
DATE (month-date)
2. While the screen you want is on the display, use the
+ and – buttons
to change the digits that are fl ashing.
Press
–
to decrease the fl ashing digits.
Press
+
to increase the fl ashing digits.
Holding down
+
or
–
changes the fl ashing digits at high speed.
You can set the year in the range of 2000 to 2099. The day of the week is set automatically in accordance
with the date setting.
Pressing
+
or
–
while the Time Setting Screen is on the display causes the seconds count to be reset to 00.
Each press of
+
or
–
while the 12-hour/24-hour Setting Screen is on the display toggles between 12-hour
and 24-hour timekeeping.
A sticker is affi xed to the glass of this clock when you purchase it. Be sure to remove the sticker before using
the clock.
Depending on the clock model, the confi guration of your clock may differ somewhat from that shown in the
illustration.
OPERATING PRECAUTIONS
Do not use or store this clock in areas exposed to temperature extremes, strong magnetism, strong vibration,
or strong impact.
Heat can shorten battery life and cause malfunction. Keep the clock away from heaters and direct sunlight
when using it.
Never use the clock in a bathroom or any other area subject to high humidity.
Never try to take the clock apart. Doing so can cause malfunction.
To clean the clock, use a soft, dry cloth or a cloth moistened in a solution of water and a mild neutral
detergent. Wring out all excess moisture from the cloth. Never use thinner, benzene, alcohol or other similar
agents.
Be sure to keep all user documentation handy for future reference.
Note that CASIO COMPUTER CO., LTD. assumes no responsibility for any damage or loss suffered by you or
any third party arising through the use of this product or its malfunction.
Important!
The times indicated by the analog clock and the digital display are not coordinated with each other. Use the
procedures below to confi gure the time settings of each one.
CONFIGURING ANALOG CLOCK SETTINGS
To start clock
Insert a battery into
analog clock battery compartment
with polarity as indicated.
To set time
Turn the
hour/minute adjuster
in either direction.
To adjust seconds
Remove the battery to stop the second hand at 12 o’clock position. Replace the battery at a time signal to restart
the second hand on the correct second.
The current time setting may be slightly off, depending on the timing when you load the battery to restart
timing.