• An attempt to generate a number table in the Table Mode whose
conditions cause it to exceed the maximum number of allowable rows.
→
Narrow the table calculation range by changing the Start, End, and
Step values, and try again.
Before Assuming Malfunction of the
Calculator...
Note that you should make separate copies of important data before
performing these steps.
1. Check the calculation expression to make sure that it does not contain
any errors.
2. Make sure that you are using the correct mode for the type of
calculation you are trying to perform.
3. If the above steps do not correct your problem, press the
key.
• This will cause the calculator to perform a routine that checks
whether calculation functions are operating correctly. If the calculator
discovers any abnormality, it automatically initializes the calculation
mode and clears memory contents.
4. Return the calculation mode and setup (except Language and Contrast
settings) to their initial default settings by performing the following
operation:
(RESET)
(Setup Data)
(Yes).
Replacing the Battery
A low battery is indicated by a dim display, even if contrast is adjusted, or
by failure of figures to appear on the display immediately after you turn on
the calculator. If this happens, replace the battery with a new one.
Important:
Removing the battery will cause all of the calculator’s memory
contents to be deleted.
1. Press
(OFF) to turn off the calculator.
• To ensure that you do not accidentally turn on
power while replacing the battery, slide the
hard case onto the front of the calculator.
2. As shown in the illustration, remove the cover,
remove the battery, and then load a new battery
with its plus (+) and minus (−) ends facing
correctly.
3. Replace the cover.
4. Initialize the calculator:
(RESET)
(Initialize All)
(Yes).
• Do not skip the above step!
Screw
Screw
Technical Information
Calculation Range and Precision
Calculation Range
±1 × 10
-99
to ±9.999999999 × 10
99
or 0
Number of Digits for
Internal Calculation
15 digits
22