Casio DT-700, Service Manual, Page: 14 / 42

Page 12
3) Attachment is performed by
following the reverse procedure
of removal. Insert the FFC joiner
into the space below the laser
module while making sure it
does not become pinched
between the upper case and
lower case.
* Do not touch the screw adjustment
above the laser module!
6-4.
Removal and Attachment of P690-MAIN Board
1) Raise out the two main battery springs on the side
on which the lead is connected.
2) Remove the two flat screws (2 x 5 Ni) and
separate the inner case from the upper case for
both the MAIN board and LCD. However,
remove the LCD carefully since it is difficult
to remove as a result of the periphery being
adhered to the upper case with double-sided
adhesive tape.
3) Remove the key film connected to the P690-
MAIN board from the connector. The key
film is removed by opening the connector
opening (dark brown portion) upward.