PAGE
19
PAGE
18
2
1
ADDITIONAL INFORMATION
Two-line installations may require a two-line
T-adapter for the CP-1260 to operate correctly.
The T-adapter allows you to connect your
machine to Line 1 or Line 2. The
CP-1260 will only operate on one line.
(See “ACCESSORIES” page 25.)
TWO-LINE INSTALLATION
Installations with more than two lines, such
as business PBX or Key Systems, may require
a separate RJ11 jack. Please contact your
telephone equipment provider for additional
information. (See “ACCESSORIES” page 25.)
MULTI-LINE INSTALLATION
CAUTION: Disconnect the CP-1260 from the
power outlet before cleaning.
Use a damp cloth or moist sponge to clean:
1. The antenna.
2. The plastic cabinet of the handset and
base.
3. The battery charging contacts on the
handset and base.
A mild soap, like dishwashing detergent, will
help remove grease or oil. Do not spray
cleaners directly onto the CP-1260. Cleaners
should only be used on the plastic surfaces.
Thoroughly dry all parts of the handset and
charging cradle before re-using.
CLEANING THE CP-1260
To install or replace the battery pack:
HANDSET BATTERY
INSTALLATION
Press down on the battery
compartment cover and slide it
toward the bottom of the handset.
(Remove old battery pack if you are
replacing a battery.)
Install the new battery pack with the
red wire below the black wire (see
drawing below).
3
Replace the battery cover by sliding it
up from the bottom.
4
Place the handset in the base unit
cradle face up or face down and charge
the battery pack for 12-15 hours.
WARNING:
Use only Ni-Cd Rechargeable
Battery Pack
(3.6 volts 600 mAh.)
THIS CP-1260 IS NOT SHIPPED WITH
THE HANDSET BATTERY PACK
INSTALLED - INSERT HANDSET
BATTERY BEFORE INITIAL SETUP
AND USE.
Unplug the CP-1260 from the wall outlet if
you wish to move the CP-1260. Place the
handset in the charging cradle after relocating
the CP-1260. All autodial numbers will be
saved.
MOVING THE CP-1260
CHANGING THE DIGITAL
SECURITY CODE
The digital security code is an identification
code to connects the handset and the base
unit. The security code is automatically set
the first time you charge the handset in the
base (see page 5). It is usually unnecessary
to reset this code. However, if another
cordless telephone appears to be using the
same code, you can change it.
NOTE:
■
Make sure that the wire is not caught in between
the battery cover.
1
2
Place the handset in the cradle.
Press
INTERCOM
on the base.
Remove the handset from the cradle
for at least 1 second, and place it back
in the cradle. Leave the handset in the
base for at least 4 seconds. A new,
random security code is set.
NOTE:
■
The digital security code is lost if the handset
battery pack is completely discharged or the
battery pack is removed. If this happens, a new
security code is set automatically the next time the
handset is charged in the cradle.
NICKLE-CADMIUM BATTERIES
MUST BE DISPOSED OF
PROPERLY.
Nickel-cadmium cells are used in
the battery pack. Please take
your nickel-cadmium battery
packs to a store that recycles
nickel-cadmium batteries.
RECYCLING NICKEL-CADMIUM BATTERIES
Summary of Contents for CP-1260
Page 15: ...PAGE 28 FEATURES ...
