Playing with Different Tones
EN-19
En
g
lish
8.
To cancel layering and switch to a single tone
(Upper 1), press the
LAYER
bu
tton or
EXIT
bu
tton.
•
Each press of the
LAYER
button toggles between
unlayered (one tone) and layered (two tones).
•
Entering the Duet Mode (page EN-17) or Duet Pan
Mode will disable layering.
•
Configuring of layering settings is not supported by
MIDI Recorder Track 2 recording.
1.
Hold down the
LAYER
bu
tton
u
ntil the screen
shown
b
elow appears.
2.
Use the
q
and
w
arrow
bu
ttons to select
“Layer Balance”.
3.
Use the
u
(–)
and
i
(+)
arrow
bu
ttons to
adj
u
st the layer vol
u
me
b
alance.
•
–1 or lower: Increases the Upper 1 tone volume.
+1 or higher: Increases the Upper 2 tone volume.
0: Upper 1 and Upper 2 volume the same.
•
The setting range is –24 to +24.
4.
To ret
u
rn to the screen yo
u
were at prior to
step 1 of this proced
u
re, press
EXIT
bu
tton.
You can use the procedure below to change the octave
of each layer.
1.
Hold down the
LAYER
bu
tton
u
ntil the screen
shown
b
elow appears.
2.
Use the
q
and
w
arrow
bu
ttons to select
the layer whose octave yo
u
want to change.
•
Upper 1: Select “Upper1 Octave”
Upper 2: Select “Upper2 Octave”.
3.
Use the
u
(–)
and
i
(+)
arrow
bu
ttons to
change the octave.
•
+1 or higher: Raises the octave by the specified value.
–1 or lower: Lowers the octave by the specified value.
0: Returns the octave to its original setting.
•
The setting range is –2 to +2.
4.
To ret
u
rn to the screen yo
u
were at prior to
step 1 of this proced
u
re, press
EXIT
bu
tton.
To adjust the volume balance between
two layered tones
L a y e r B a l a n c e
To chan
g
e the octave of each layer
