— 20 —
(3) To do data transfer
Please switch both units on, and make them enter the MENU1 mode. Thus you may start to
transfer all data of customer’s unit to the receiving unit following the procedure shown below.
SLAVE UNIT
MASTER UNIT
Note: The TEST means the short-circuit operation as shown in figure on the next page:
TEST Over 2 seconds
EXE
AC
1
2
MENU 1
MENU 1
TEST
Over 2 seconds
EXE
1
AC
1
Sending
failed
Receiving
failed
Sending succeeded
Receiving succeeded
MENU 1
MENU 1
Rcv Error !
Send Error !
Caution!
This is TEST
To Escape
Press AC KEY
1. Service Trans
2. TEST
AC. Esc
Service Trans
1. TRANS
2. RCV
AC. ESC
Receive OK!
To Stop
Press AC KEY
Caution!
This is TEST
To Escape
Press AC KEY
1. Service Trans
2. TEST
AC. Esc
Service Trans
1. TRANS
2. RCV
AC. ESC
Now Sending!
To Stop
Press AC KEY
