Operation Guide 4380 4396 5048
4
Illumination
This watch has an EL (electro-luminescent) panel that
cause the face of watch to glow for easy reading in the
dark.
•
See “Illumination Precautions” for other important
information about using illumination.
To illuminate the face of the watch
In any mode (except when a setting screen is on the
display), press
B
to illuminate the face of the watch.
•
You can use the procedure below to select either
1.5 seconds or 3 seconds as the illumination duration.
When you press
B
, the illumination will remain on for
about 1.5 seconds or 3 seconds, depending on the
current illumination duration setting.
To specify the illumination duration
1. In the Timekeeping Mode, hold down
A
until the
seconds start to flash, which indicates the setting
screen.
2. While the seconds are flashing, press
B
to toggle the
illumination duration between 1.5 seconds ( ) and 3
seconds ( ).
3. Press
A
to exit the setting screen.
Reference
This section contains more detailed and technical information about watch operation.
It also contains important precautions and notes about the various features and
functions of this watch.
Auto Return Feature
•
If you leave a screen with flashing digits on the display for two or three minutes
without performing any operation, the watch saves any settings you have made up to
that point and exits the setting screen automatically.
•
The watch will change to the Timekeeping Mode automatically if you do not perform
any operation in the Recall Mode, Alarm Mode, or Hand Setting Mode for two or
three minutes.
Button Operation Tone
The button operation tone sounds any time you press one of the watch’s buttons. You
can turn the button operation tone on or off as desired.
•
The multi-function alarms and Countdown Timer Mode alarm will sound even if the
button operation tone is turned off.
To turn the button operation tone on and off
In any mode (except when a setting screen is on the display), hold down
C
to toggle
the button operation tone on (mute indicator not displayed) and off (mute indicator
displayed).
•
Holding down
C
to turn the button operation tone on or off also causes the watch’s
current mode to change.
•
The mute indicator is displayed in all modes when the button operation tone is
turned off.
Module 4380
Module 5048
Module 4396
Scrolling
The
B
and
D
buttons are used in various modes and setting screens to scroll
through data on the display. In most cases, holding down these buttons during a scroll
operation scrolls through the data at high speed.
Timekeeping
•
Resetting the seconds to
00
while the current count is in the range of 30 to 59
causes the minutes to be increased by 1. In the range of 00 to 29, the seconds are
reset to
00
without changing the minutes.
•
The year can be set in the range of 2000 to 2099.
•
The watch’s built-in full automatic calendar makes allowances for different month
lengths and leap years. Once you set the date, there should be no reason to change
it except after you have the watch’s batteries replaced.
Illumination Precautions
•
The electro-luminescent panel that provides illumination loses power after very long
use.
•
Illumination may be hard to see when viewed under direct sunlight.
•
The watch may emit an audible sound whenever the display is illuminated. This is
due to vibration of the EL panel used for illumination, and does not indicate
malfunction.
•
Illumination turns off automatically whenever an alarm sounds.
•
Frequent use of illumination runs down the batteries.