Casio 5699, Operation Manual, Page: 11 / 14

Timing the First and Second
Place Finishers
1.
Enter the Stopwatch Mode.
l
Navigating Between Modes
2.
Use the operations below to measure
elapsed time.
D
A
D
A
2nd Finisher
1st Finisher*1
Split release*2
Start
*1
Displays the time of the first finisher.
*2
Displays the time of the second finisher.
Hours, minutes
Seconds, 1/100 seconds
3.
Press (A) to reset the stopwatch to all
zeros.
Timer
The timer counts down from a start time
specified by you. A beeper sounds when the
end of the countdown is reached.
Setting the Countdown Start
Time
●
The countdown start time can be set in 1-
minute units up to 24 hours.
●
If a timer countdown operation is in
progress, reset the timer to its current start
time before performing this operation.
l
Using the Timer
1.
Enter the Timer Mode.
l
Navigating Between Modes
2.
Hold down (A) for at least one second.
Release the button when the hour setting
starts to flash.
Hours
3.
Use (B) and (D) to change the timer hours
setting.
●
Holding down (B) or (D) scrolls through
settings at high speed.
4.
Press (C).
This causes the minutes digits to flash.
Minutes
5.
Use (B) and (D) to change the minutes
setting.
6.
Press (A) to complete the setting
operation.
Note
●
Setting a start time of “0:00” will
perform a countdown of 24 hours.
●
While the setting is being configured,
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
Using the Timer
The timer counts down time in 1-second units.
1.
Enter the Timer Mode.
l
Navigating Between Modes
Hour, minute
Seconds
2.
Use the operations below to perform a
timer operation.
D
D
D
(Time up)
Resume
Pause
(Countdown starts)
Start
●
A beeper will sound for 10 seconds to
let you know when the end of a
countdown is reached.
●
You can reset a paused countdown to
its start time, by pressing (A).
3.
Press any button to stop the tone.
Watch Operation Guide 5699
11