Casio 5623, Operation Manual

Page: 18 / 26

Checking the Current Tide
Level in the Specified Port
Entering the Tide Graph Mode displays the
current time and tide conditions in the port you
specified with G-SHOCK Connected.
1.
Enter the Tide Graph Mode.
l
Navigating Between Modes
30
① ②
③ ④
A
Time in your current location
B
Tide conditions in the specified port
C
Current time in the specified port
D
Current location date
Note
●
The tide level display is based on the
summer time setting of the port that
was specified when you enter the Tide
Graph Mode.
●
Interpreting Displayed Tide Conditions
The mode hand points to the current tide level
in the specified port.
Low tide
High tide
Low tide
Note
●
The tide is indicated as one of six
levels.
●
If the tide level is not being indicated
correctly, adjust the high tide time.
l
Adjusting High Tide Times
Adjusting High Tide Times
You can improve the accuracy of the
displayed high tide by adjusting the high tide
time in accordance with information available
on the internet or in a newspaper.
1.
Enter the Tide Graph Mode.
l
Navigating Between Modes
2.
Loosen the crown and then pull it out to the
first click.
3.
Rotate the crown to change the high tide
time setting.
30
Crown
Current location time
High tide time in the specified port
4.
Push the crown back in and then lock it.
Note
●
For a location where there are two high
tides per day, set the time of the first
high tide. The watch will automatically
calculate the time of the second high
tide.
●
If the specified port is in a time zone
that is different from your current time
zone, there may be cases when the
date in the port is different from the
displayed date.
●
If summer time is in effect in the
specified port, you should also use
summer time when specifying the high
tide time.
Stopwatch
The stopwatch measures elapsed time in units
of one second up to 23 hours, 59 minutes, 59
seconds (24 hours).
30
Measuring Elapsed Time
30
Minutes
Hours
Seconds
Hours (24-hour time)
1.
Enter the Stopwatch Mode.
l
Navigating Between Modes
2.
Use the operations below to measure
elapsed time.
Stop
Resume
Stop
Start
3.
Press (A) to reset the elapsed time to all
zeros.
Operation Guide 5623
18