Swapping the Home City
Time and World Time (Dual
Time)
In the Calendar Mode, you can swap your
Home City time with your Dual Time by holding
down (B) for at least three seconds.
30
30
After swapping
Before swapping
Dual Time
Dual Time
Home Time
Home Time
●
If a swapping operation causes a change in
the day indicator setting, the mode hand will
rotate repeatedly.
l
Hand and Day Indicator Movement
Note
●
This function comes in handy when
you need to move to another time
zone. For details about how to use it,
go to the section below.
l
Using the Diving
Function
You can use the procedures in this section to
keep track of your dive time and surface
interval. The watch automatically records
diving log data. There is memory for up to 30
diving log data records. Recording diving log
data when there are already 30 log data
records in memory will automatically cause
the oldest log record to be deleted to make
room for the new one.
30
●
You can use diving log data to view the
items below.
ー
Dive start date and time
ー
Dive time
ー
Surface interval
ー
Location information
You can use G-SHOCK Connected to view
recorded diving log data.
l
Important!
●
Check to make sure the crown is
locked before using the watch for
diving.
●
If the battery is low or dead, charge it
before using the watch for diving.
●
Before starting a dive (while still on the
boat or on the water’s surface), enter
the Dive Mode.
●
Do not operate the crown while the
watch is wet.
●
Should battery power go low, the
watch will stop time measurement and
switch to the Calendar Mode.
●
Avoid over use of display illumination
while diving. Overuse of illumination
may cause the watch to exit the Dive
Mode or may cause hand movement to
stop in order to maintain watch
operation. This can also cause all
watch operation to be momentarily
disabled.
Measuring Elapsed Dive
Time
Dive time is measured in units of one second
up to 1 hour, 59 minutes, 59 seconds (2
hours).
●
Even if elapsed dive time measurement
continues for longer than the maximum dive
time of two hours, the hands will continue to
move for 24 hours.
1.
Enter the Dive Mode.
l
The hour hand, minute hand, second
hand, and 24-hour hand will all move to 12
o’clock, which indicates that the watch is
ready to start dive time measurement.
2.
Press (D).
This starts dive time measurement.
Example: Dive time measurement 5
minutes 26 seconds
30
Dive time minutes
Current time
Dive time seconds
Dive time hours (2 hours per rotation)
●
The hour and minute hands move
together.
3.
Hold down (D) for at least two seconds to
stop dive time measurement.
This starts surface interval measurement.
Note
●
If the watch is in the Dive Mode,
loosening the crown and then pulling it
out to the first click will cause the
current elapsed dive time to be reset to
zero.
●
The period from the point you enter the
Dive Mode until you next enter the
Calendar Mode is treated as the same
dive.
●
To create a separate log record for a
dive such as when repetitive diving,
enter the Calendar Mode and then
return to the Dive Mode.
●
If you do not perform any watch
operation for about 24 hours after
starting dive time measurement,
measurement will stop and the hands
will return to 12 o’clock.
Operation Guide 5623
16
