Casio 5537, Operation Manual, Page: 13 / 23

Using the Timer
1.
Use the operations below to perform a
timer operation.
A
E
E
(Time up)
Resume
Pause
(Countdown starts)
Start
●
A beeper will sound for 10 seconds to
let you know when the end of a
countdown is reached.
●
To reset a paused countdown to the
start time, press (A).
2.
Press any button to stop the tone.
Alarms and Hourly Time
Signal
The watch will beep when the alarm time is
reached. You can set up to five different
alarms. The hourly time signal causes the
watch to beep every hour on the hour.
●
The alarm sound is muted in the cases
described below.
ー
When battery power is low
ー
When watch is at Level 2 power saving
l
Power Saving Function
Getting ready
Enter the Alarm Mode.
l
Navigating Between Modes
Configuring Alarm Settings
1.
Press (E) to scroll through alarm numbers
([AL1] to [AL5]) until the number of the
alarm you want to configure is displayed.
Alarm number
Alarm time
2.
Hold down (A) for at least two seconds.
Release the button when the hours digits
start to flash.
Hours
3.
Use (B) and (E) to change the hour setting.
●
If you are using 12-hour timekeeping,
[P] indicates p.m.
4.
Press (D).
This causes the minutes digits to flash.
Minutes
5.
Use (B) and (E) to change the minute
setting.
6.
Press (D).
This causes the alarm type to flash.
7.
Use (E) to select the alarm type.
[DAILY]: Alarm sounds every day at the
alarm time.
[1TIME]: Alarm sounds only once at the
alarm time.
[SCHEDULE]: Alarm sounds on the
specified date.
l
Setting a Schedule Alarm
8.
Press (A) twice to exit the setting screen.
9.
Hold down (D) for at least two seconds to
return to the Timekeeping Mode.
Setting a Schedule Alarm
With [SCHEDULE], you can specify the year,
month, and day that you want an alarm to
sound.
●
Creating a Schedule Alarm
There are various schedule alarm types, and
the type that is set depends on the year,
month, and day settings you configure.
Three typical setting configurations are shown
below, but other configurations are also
possible.
A
Year, month, day all specified
The alarm sounds once at the specified time
on the specified date.
B
Year, month, day partially specified
●
Specifying only the year will cause the
alarm to sound at the specified time
every day of the specified year.
●
Specifying only the month and day will
cause the alarm to sound at the
specified time on the specified date
every year.
You can also create a schedule alarm by
specifying the month only, day only, year and
month only, and year and day only.
C
Year, month, day not specified (Display:
[----.--.--])
In this case, the alarm will sound at the
specified time every day.
1.
Press (E) to scroll through alarm numbers
([AL1] to [AL5]) until the number of the
alarm you want to configure is displayed.
Alarm number
Alarm time
Operation Guide 5537
13