Setting the Countdown Start
Time
The countdown start time can be set in 1-
second units up to 24 hours.
●
If a timer countdown operation is in
progress, reset the timer to its current start
time before performing this operation.
l
1.
Hold down (A) for at least two seconds.
Release the button when the hour digits
start to flash.
This causes the hours digit to flash.
Hours
2.
Use (D) and (E) to change the timer hours
setting.
3.
Press (C).
This causes the minutes digits to flash.
Minutes
4.
Use (D) and (E) to change the timer
minutes setting.
5.
Press (C).
This causes the seconds digits to flash.
Seconds
6.
Use (D) and (E) to change the timer
seconds setting.
7.
Press (A) to exit the setting screen.
Using the Timer
1.
Use the operations below to perform a
timer operation.
D
D
D
(Time up)
Resume
Pause
(Measurement operation starts.)
Start
●
A beeper will sound for 10 seconds to
let you know when the end of a
countdown is reached.
●
To reset a paused countdown to the
start time, press (E).
2.
Press any button to stop the tone.
Alarms and Hourly Time
Signal
The watch will beep when the alarm time is
reached. You can set up to five different
alarms. The hourly time signal causes the
watch to beep every hour on the hour.
●
The alarm sound is muted in the cases
described below.
ー
When battery power is low
ー
When watch is at Level 2 power saving
l
Getting ready
Enter the Alarm Mode.
l
Configuring Alarm Settings
1.
Press (D) to scroll through alarm numbers
([AL1] to [AL5]) until the number of the
alarm you want to configure is displayed.
Alarm time
Alarm number
2.
Hold down (A) for at least two seconds.
Release the button when the hours digits
start to flash.
Hours
3.
Use (D) and (E) to change the hours
setting.
●
If you are using 12-hour timekeeping,
[P] indicates p.m.
4.
Press (C).
This causes the minutes digits to flash.
Minutes
5.
Use (D) and (E) to change the minutes
setting.
6.
Press (C).
This causes the alarm type to flash.
Operation Guide 5536
11
