1.
Enter the Barometer/Temperature Mode.
l
2.
Hold down (B) for at least two seconds.
If Barometric Pressure Change
Indications are enabled, [INFO]
[Hold]
[On] flash on the display, and then [BARO]
appears.
3.
To disable Barometric Pressure Change
Indication, hold down (B) again for at least
two seconds.
[INFO]
[Hold]
[OFF] flash on the display,
and then [BARO] disappears.
Note
●
If the Barometric Pressure Change
Indication is enabled, readings are
taken every two minutes even while the
watch is not in the Barometer/
Temperature Mode.
●
The Barometric Pressure Change
Indication becomes disabled
automatically 24 hours after it is
enabled.
●
Power Saving is disabled while
barometric pressure trend information
is enabled.
l
●
You will not be able to turn on
Barometric Pressure Change
Indication while the charge level of the
watch’s battery is low.
●
Low battery power will also cause
Barometric Pressure Change
Indication to turn off.
Correcting Measured
Barometric Pressure and
Temperature Values (Offset)
The watch’s built-in pressure sensor and
temperature sensor are adjusted at the factory
and normally do not require correction.
However, you can correct the displayed value
if you notice major errors in readings.
Important!
●
The watch will not be able to produce
correct barometric pressure readings if
you make a mistake during the
correction procedure. Check to ensure
that the values you use for calibration
produces correct pressure and
temperature readings.
●
Before adjusting the temperature
sensor, remove the watch from your
wrist and leave it in the area where you
plan to measure temperature for about
20 or 30 minutes to allow the case
temperature to become the same as
the air temperature.
1.
Enter the Barometer/Temperature Mode.
l
2.
Hold down (E) for at least two seconds.
Release the button when [TEMP] appears
on the display.
This causes the temperature reading to
flash on the display.
Barometric pressure
Temperature
3.
Press (D) to select the temperature
correction or barometric pressure
correction screen.
Barometric pressure
correction screen
Temperature
correction screen
4.
Use (A) and (C) to change the value.
Temperature Setting Unit: 0.1 °C (or
0.2 °F)
Barometric Pressure Setting Unit: 1 hPa
(or 0.05 inHg)
●
Holding down (A) or (C) scrolls through
settings at high speed.
●
To return the barometric pressure
setting to its initial factory default, press
(A) and (C) at the same time.
5.
Press (E) to complete the setting
operation.
Note
●
While the setting is being configured,
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
Watch Operation Guide 3513
24
