Casio 3495, Operation Manual, Page: 14 / 19

4.
Use (B) and (D) to change the hour setting.
●
Holding down (B) or (D) scrolls through
settings at high speed.
●
If you are using 12-hour timekeeping,
[P] indicates p.m.
5.
Press (C).
This causes the minutes digits to flash.
Minutes
6.
Use (B) and (D) to change the minute
setting.
7.
Press (A) to exit the setting screen.
● To stop the alarm
To stop the alarm after it starts to sound when
an alarm time is reached, press any button.
Snooze causes the alarm to sound up to seven
times, at five-minute intervals. To cancel a
snooze alarm, turn [SNZ] off.
l
Turning Off an Alarm or the Hourly Time
Signal
Note
●
A beeper will sound for 10 seconds to
let you know when the alarm time is
reached.
●
The watch will automatically return to
the Timekeeping Mode from the Alarm
Mode after two or three minutes of non-
operation.
Configuring the Hourly Time
Signal Setting
1.
Enter the Alarm Mode.
l
Navigating Between Modes
2.
Press (D) to display the hourly time signal
screen ([SIG]).
3.
Press (A) to toggle the hourly time signal
between enabled (on) and disabled (off).
●
[SIG] (hourly time signal) is shown on
the display while the hourly time signal
is enabled.
Turning Off an Alarm or the
Hourly Time Signal
To stop an alarm or the hourly time signal from
sounding, perform the steps below to turn it
off.
●
To have an alarm or hourly time signal
sound again, turn it back on.
Note
●
Indicators are displayed while any of
the alarms or the hourly time signal is
turned on.
●
The applicable indicators are not
displayed while all of the alarms are
turned off and/or the hourly time signal
is turned off.
Alarm
Snooze Hourly time signal
1.
Enter the Alarm Mode.
l
Navigating Between Modes
2.
Use (D) to display the item whose on/off
setting you want to change: alarm number
[1] to [4] or [SNZ], or the hourly time signal
([SIG]) screen.
Alarm or hourly time signal
3.
Press (A) to turn off the displayed alarm or
the hourly time signal.
●
Each press of (A) toggles between ON
and OFF.
●
Turning off all alarms will cause [ALM]
(alarm) to disappear from the display,
while disabling the hourly time signal
causes [SIG] (hourly time signal) to
disappear from the display.
Note
●
If [ALM] (alarm) is still displayed, it
means that another alarm is still turned
on. To turn off all of the alarms, repeat
steps 2 and 3 until the [ALM] (alarm)
indicator is no longer displayed.
Watch Operation Guide 3495
14