Acquiring GPS Position Information
Manually
You can use a button operation to acquire
GPS location information and adjust your time
zone, time, and day settings in accordance
with your current location.
Note
●
GPS signal reception requires large
amounts of power. Perform it only
when necessary.
1.
Move to a location appropriate for signal
reception and point the LCD of the watch
straight up at the sky.
2.
Press (D).
Rotary Switch
3.
Rotate the rotary switch to move the
pointer to [TIME&POSITION].
4.
Press the rotary switch.
This starts location information
acquisition.
●
The acquired information will appear on
the watch display when location
acquisition is successful.
Rotary Switch
●
[RECEIVING FAILED] will appear on
the display if location information
acquisition fails for some reason.
5.
Press (C) to exit the setting screen.
Note
●
Receive normally takes anywhere
from about 40 to 80 seconds.
●
It can take as long as 13 minutes when
leap second information is included.
●
You may experience location
information acquisition problems when
you are in the vicinity of a city
borderline.
The watch’s time and day will not be
indicated correctly if the time zone
setting is not right for your location. If
this happens, move to a location near
the center of the city you want to set as
your Home City and acquire location
information again. Or you can perform
a time information receive operation to
adjust time and day settings after
configuring Home City and summer
time settings manually.
l
Acquiring GPS Time Information
Manually
l
Configuring Home City and
Summer Time Settings
Acquiring GPS Time Information
Manually
You can use a button operation on the watch
to receive GPS signal time information. When
the receive operation is successful, the
watch’s Home City (time zone), day, and time
settings will be adjusted accordingly.
Note
●
GPS signal reception requires large
amounts of power. Perform it only
when necessary.
1.
Move to a location appropriate for signal
reception and point the LCD of the watch
straight up at the sky.
2.
Hold down (D) for about 1.5 seconds.
This starts time information acquisition.
●
The acquired information will appear on
the watch display when time acquisition
is successful.
●
[RECEIVING FAILED] will appear if
acquisition fails for some reason.
3.
Press (C) to exit the setting screen.
Note
●
You can also trigger a time information
receive operation manually by
performing the steps below.
A
Press (D).
B
Rotate the rotary switch to move the
pointer to [TIME (GPS)].
C
Press the rotary switch.
●
Receive normally takes anywhere
from about 10 to 65 seconds.
●
It can take as long as 13 minutes when
leap second information is included.
Operation Guide 3452
10
