Operation Guide 2782
8
3. After waiting four or five seconds,
C
to move
the flashing to the pressure sensor calibration
setting.
•
At this time,
OFF
or the barometric
pressure value should be flashing on the
display.
•
If
OFF
or the pressure value does not
appear at this time, press
A
to return to the
Barometer/Thermometer Mode screen, and
perform step 2 again.
4. Press
D
(+) or
B
(–) to change the displayed barometric pressure by 1
hPa (0.05 inHg).
•
Pressing
D
and
B
at the same time returns to the factory calibration
(
OFF
).
5. Press
A
to return to the Barometer/Thermometer Mode screen.
ll
ll
l l
l l l l l l l l
ll
ll
ll
To change the altitude unit
1. Press
D
to enter the Altimeter Mode.
2. Hold down
A
until
OFF
appears (flashing) or
until the display goes blank. This is the setting
screen.
•
Wait for four or five seconds before
performing step 3, below. If you don’t wait,
there is the chance of setting value error.
•
If the display went blank in step 2, the
current reference value will appear
(flashing) on the display after the four or five
seconds pass.
•
If
OFF
or the current reference altitude value does not appear at this
time, press
A
to return to the Altimeter Mode screen, and perform step
2 again.
3. Press
C
to move the flashing to the altitude unit setting.
ll
l l
l l l
ll
4. Press
D
to select the unit you want (
m
or
ft
).
5. Press
A
to return to the Altimeter Mode screen.
•
The altitude unit you select in the Altimeter Mode is also used in the Depth
Gauge Mode.
To manually reset the reference depth to 0 meters (feet)
In the Depth Gauge Mode, press
C
and
D
at
the same time.
•
This resets the reference depth and causes the
displayed depth to change to 0 meters (feet).
•
Never perform the above operation while
submerged.
